Powerlogger & cell 5 blm

[bobbybuick]

Eric, is there a way to get cell 5 on blm grid to show up on graph screen via INI? also didnt you have a way to make it a % in lieu of numbers?
Also Im on pos E and still only 82%DC.I kept turning up the thumbwheel and it is still adding fuel to get target of 11.0... FP is 76 with 26psi boost
seems that pos C-D-E isnt adding that much fuel between positions any ideas they look about the same on PL. running 96lb injectors and seems if i could get to 85%DC i could start turning boost up. So far on pos E ran 9.64 82%DC BLM went to around 140 on a couple frames
Im running PL version 1.4

 

[EricM]

You can add these lines at the beginning of the PLC.ini file:

[Debug]
TurboTweakSD=1


That will make AFR correction show up as a percent and you can view it on the graph page. You might not see it on old logs.

I'm looking at your chip file, at the fueling. As far as the last few positions not changing DC, it won't if you have closed loop on, and it's meeting the target A/F. But the correction should get lower and lower as you go up. I should be able to add some base fuel to get the correction down more.