PL Updated to 2.6.8(PL052.s19) and now SM goes blank

[sd-slider]

I connected to my PL using a new laptop and was able to connect but had a version mismatch.

I followed the instructions for updating the PL using the 2.6.8 download and everything went as planned with the exception of my SM now flashing the "SM 2.2" and PL version is represented by "rolling" integers.

If I attempt another PL re-flash, I see "- - - - - - - -" on the SM for a moment and then it goes black.

PL is connecting and logging fine, the SM however just flashes the version info and goes blank with every power cycle.

Any ideas or suggestions?

Eric Brown
San Diego, CA

 

[EricM]

Go to the scanmaster options and make sure the Scanmaster G option is turned off.

 

[sd-slider]

I'll give it a shot. Thanks.

 

[EricM]

You'll have to be connected and monitoring when you make the change.

 

[sd-slider]

Thanks!

Read that in the manual after making the change. Works great.

Thanks for the feedback and service!

=Eric