max effort WB with modded ecm and pl

B

bobbybuick

Member
Eric just making sure everything is corretly wired
lm1 is connected to ground and number 1 on block.
Modded ECM map wire (green )connected to number 2 on block
scanmaster is connected to number 7 on block
I did not hook 2 remaining wires on map input due to power coming from modded ecm
is this correct?my ecm was modded for map input only not wb input
 
Last edited:
EricM

EricM

Administrator
Staff member
Which chip are you using? Is this the 95lb one?

For the LM1 ground, only the analog output ground would go to the PL block. Make sure you did not connect the main ground from the LM1. I'm not sure if the LM1 has it's own analog output ground.

You are correct on the rest of the wiring.
 
B

bobbybuick

Member
yes the 95 lb chip you did for me .the only ground from the lm1 is on the analog output cable
thanks bob
on a side note .I could have run a non modded map ecm with the powerlogger.Hooked all 3 wires from the map to the block and it would work the same?
 
EricM

EricM

Administrator
Staff member
Yes, that chip uses the inputs from the Powerlogger (MAP and WB), so you don't need a MAP modded ECM.
 
EricM

EricM

Administrator
Staff member
Make sure you've programmed the LM-1 to mimic the LC-1 output, and then set the powerlogger to LC-1 also.
 
B

bobbybuick

Member
BLM or CC

Eric, couple of questions.on the correction does it read out on scanmaster in cc or blm.it says in the directions the correction number from 128 reads in cc.I thought ypou made a chage for % to read in blm.Also do you remember if my chip has 2 timing settings where 7 is richer than 8.or am I single timing richer all the way up the chip
 
EricM

EricM

Administrator
Staff member
If you have the scanmaster connected to the aldl port under the radio then the correction will display in the CC position, not as a % though. If you have the scanmaster connected to the powerlogger, then you may not be able to see the correction on the scanmaster. I haven't tested that yet.

You can see the correction in the BLM grid. It should be the 2nd cell down on the left side.

If you update to the lastest powerlogger software (1.3.22), you can see the correction on the graph tab and data tab as %. Follow the intructions on the last 2 pages of the SD chip instructions, here: http://www.turbotweak.com/turbotweaksdq.pdf
 
You must log in or register to reply here.
Top