first tune with PL & MEr WB

[bobbybuick]

Eric will you look at these the one that says first pass was on pos C TB hose blew off .
I moved it to pos E and got a WB lean spike.
Also no data on correction other than data screen can you tell me what to change to get it on the graph page.
you said just type in
[debug]
TurboTweekSD = 1

i will try that
i will try to reflash
im thinking I got it so rich the spikes are from burning raw fuel and fooling the WB thoughts?
Also what numbers in the yellow screen represent what modes?
is 72 spoolup because it is way lean
is 8 0-1900
is 76 1900-4000
is 108 wot

 

[EricM]

Make sure it looks like this:

[Debug]
TurboTweakSD = 1

and reflash with PL024g.S19 or newer.

You will have to make a recording after you make those changes for it to apply.

I see those spikes a lot with Innovate widebands. Make sure the grounds are good. But it also could be misfires. It doesn't appear to be too rich though, but it's hard to tell.

You can also set the wideband input "smoothing" to medium to help out in PL software.

 

[bobbybuick]

Eric i noticed on the file i sent you as soon as it went past 3000 rpm it dropped fron 9.8 to 1 to 14.5 to 1 .what are the modes ?it was on 72 when it dropped .I thought it was 1900 to 4000 .would that be in the map gain setting or is there a change from 3000 ..What are the codes to read out in cell number1

 

[EricM]

I don't know. I'll have to dig into that. I'm thinking you'll have to take the MAP gain (1900-4000) down to richen it up in that range.

 

[EricM]

There are no modes for the MAP gains. It just looks at RPM for that.

72 means it hit 255 on MAF, 76 is still in spool mode, 108 is WOT fuel (thumbwheel setting)