Back for more Eric. I had this problem before, but never had time to track down and answer. My AEM WB Gauge reads at least a full point less than the SM and PL readings. I have the AEM 0/5 selected in the PL, and have also tried all of the other settings to see if I could get them to match up.
This is an example of the readings. Gauge=12.9 SM and PL=14.0-14.4 Obviously they are continually jumping around.
I'm using the 6.1 WB chip, and I want to make sure that it is using the WB corrections with an accurate WB reading.
I tried adjusting it though the Analog # in the config page, but I can't get any numbers to type in there.
Thanks again, Cory
This is an example of the readings. Gauge=12.9 SM and PL=14.0-14.4 Obviously they are continually jumping around.
I'm using the 6.1 WB chip, and I want to make sure that it is using the WB corrections with an accurate WB reading.
I tried adjusting it though the Analog # in the config page, but I can't get any numbers to type in there.
Thanks again, Cory