Timing question

[larrym]

If I make an overall timing change in parameter 9 in the chip will they be visible on the spark tables on the tune page?
I changed to E65 and made changes to parameter 13 to compensate for that but wanted a couple degrees more timing also when I added it to parameter 9 I could not see the change on the spark table page.

 

[EricM]

No, you won’t see it on the table. It adds on after it reads the table.

 

[larrym]

Ok next question I did a couple “test hits” i rolled into the throttle in drive WOT I was seeing 22.5 degrees of timing boost was at around 23 psi. I went into the timing table and it showed 19.3 degrees this was without any changes in parameter 9 is that what’s in the chip? If I pull timing on the timing page will it show on the Data page

 

[EricM]

The chip is set up to add 2 degrees in 1st and 2nd gear.

 

[larrym]

Thanks for the quick reply Eric this was in drive that’s what had me confused. My speed sensor seems to be working fine can I pull timing on the advance tuning page and will it show on the data page after?

 

[larrym]

here is the log if that helps.

 

[EricM]

Ok, it looks like you have increased param 13 (fuel composition). There is a table (on the tune page under 'tables') called SPK_Alc, which adds timing based on fuel composition. I recommend setting the entire table to zero, so it doesn't add any spark. That should get you closer to what's on the spark table.