Quick pull and drive on E75

[Rob Hinson]

Just got the E85 conversion done. have a flex enabled with sensor.

Attached a log on a 17lb pull. Pulls really hard for that psi. Now what do I need to expect and do to the VE table higher up in the KPA range as I increase boost. Don't want to lean it out and hurt things.

Thanks guys

 

[EricM]

Looks pretty good.

VE will not increase much with more boost normally. I would make it approximately 3% higher than where you are now at 17psi (220kpa) in the 300kpa row and blend it in between. Then creep up boost slowly and see how close it is.

 

[Rob Hinson]

Ok awesome, that quick hitter 1 deg of knock. Has to be fake. She pulls hard and I made some adjustments in the 35-40kpa range at 2400-2800rpm. Look like it the correction was high there. And I also took some fuel out on the spool up area looked like it was fat there. 10.4ish