New to the syclones and I haven't set up TunerPro to capture any logs yet. Chip has 93 octane and Alc loaded, I'm on the alc program.
I have the dip switches set to On On Off On with AEM WB and 60lb injectors/3 bar MAF, the rotary switch for idle is at 4 clicks clockwise from 8. My issue is AFR drifts from 13-13.5 to 16-17. I'm stumped why there is any variation with the chip set to open loop idle??
Should I return the rotary switch back to 8 and go closed loop idle?
Edit: Returned rotary idle switch to 8 and set up closed loop idle. AFR hovers around 14.7 and BLM is 136. I preferred the open loop idle around 13.5, was smoother. Base FP is set to 42 psi.
Tried to get TunerPro RT set up, used the ADX at the top of the forum (ADXverlosytyBlack.adx), connected laptop through bluetooth (it will pair), but after setting up the Preferences as per the instruction, at the bottom of the screen it flashes back and forth between DA:Connected and DA: Data Error, and the Error count increments up. Also in the bottom left corner it say Not Emulating, then Hardware Not Found.
So I tried to ALDLDroid set up with the same adx, I go to connect and it hangs at Connecting for a few seconds, the switches to Disconnected?? I can get ALDLDroid to work in the Buick so I'm not sure what's going on.
Mike
I have the dip switches set to On On Off On with AEM WB and 60lb injectors/3 bar MAF, the rotary switch for idle is at 4 clicks clockwise from 8. My issue is AFR drifts from 13-13.5 to 16-17. I'm stumped why there is any variation with the chip set to open loop idle??
Should I return the rotary switch back to 8 and go closed loop idle?
Edit: Returned rotary idle switch to 8 and set up closed loop idle. AFR hovers around 14.7 and BLM is 136. I preferred the open loop idle around 13.5, was smoother. Base FP is set to 42 psi.
Tried to get TunerPro RT set up, used the ADX at the top of the forum (ADXverlosytyBlack.adx), connected laptop through bluetooth (it will pair), but after setting up the Preferences as per the instruction, at the bottom of the screen it flashes back and forth between DA:Connected and DA: Data Error, and the Error count increments up. Also in the bottom left corner it say Not Emulating, then Hardware Not Found.
So I tried to ALDLDroid set up with the same adx, I go to connect and it hangs at Connecting for a few seconds, the switches to Disconnected?? I can get ALDLDroid to work in the Buick so I'm not sure what's going on.
Mike
Last edited: