Eric,
Talked to Steve on the A/F readings I am getting on the scanmaster showing a different value than the W/B reader. Do I add or remove values into the ECM if the scanmaster is showing lower or greater values to reflect the readings shown on the W/B reader? Steve said that the AF position and the WB reader should show the same value and I am wondering if I have the WB input wires connected properly.
I contacted B.Bailey on the input wires leading to the ECM to from the FJO WB sourcee to see if the connection is the problem. He said that he was not familier with the FJO WB and didnt have an answer.
There seems to be a gap in the instructions from Baileys ECM grey and white leads to the FJO 02 sensor. There is a connector that has four input/output leads from the WB Unit. A,B,C and D. C & D are Power and Ground and two others "A" & "B" I think go to the ECM input grey & white wires Correct? If so, which wire goes to which lead from the WB? Or do I have another problem?
Talked to Steve on the A/F readings I am getting on the scanmaster showing a different value than the W/B reader. Do I add or remove values into the ECM if the scanmaster is showing lower or greater values to reflect the readings shown on the W/B reader? Steve said that the AF position and the WB reader should show the same value and I am wondering if I have the WB input wires connected properly.
I contacted B.Bailey on the input wires leading to the ECM to from the FJO WB sourcee to see if the connection is the problem. He said that he was not familier with the FJO WB and didnt have an answer.
There seems to be a gap in the instructions from Baileys ECM grey and white leads to the FJO 02 sensor. There is a connector that has four input/output leads from the WB Unit. A,B,C and D. C & D are Power and Ground and two others "A" & "B" I think go to the ECM input grey & white wires Correct? If so, which wire goes to which lead from the WB? Or do I have another problem?
