AEM 30-4110

[Anthony Alessio]

Eric, I have the 6.1 chip installed in my 87 GN. I was running the AEM 30-4110 wideband with it. my sensor looks to have failed. I can easily replace the sensor or was thinking of going with the X series. I notice the scaling on the 4110 5 volt out is 10 to 20:1 AFR, I was looking to replace the system with an X series because they claim a faster response time , but the 5 volt output is scaled from 8.5 to 18.0:1. Questions, would the electronics in our car see the increased speed and would the chip need re-programmed to sync with the different scale.
Thanks,
Anthony

 

[EricM]

The faster response won't really benefit the closed loop correction. We would have to reprogram the chip for the different scaling.

 

[Anthony Alessio]

Thanks Eric, will just replace the sensor. Also, just as a side question, , does the low end of 10:1 AFR cause concern where as the X model starts at 8 (8.5 analog out)? that probably would have been my biggest concern. If I would have known that before I purchased, I would have definitely went with the X series.