6.1 with power logger closed loop selection

[Wodmaster715]

New to TR world just finish my 87 GN restore. Have 6.1 chip with power logger running e85. Trying to make sure I have everything turned on in the PL that I need so I won’t make a mess of things. I can’t find the closed loop box to “check” to see if it’s on or off. I would like it “on” so it uses the wide band and adjusts the fuel. I have selected my wideband selected and it’s set to “in-line”. Any help or advice greatly appreciated.

 

[EricM]

The closed loop box on the data page is not related to WOT closed loop for the 6.1 chip. The closed loop correction is enabled when a target AFR (other than 9.9) is in the target AFR parameters. If set to 9.9, then its disabled.

For the wideband type, you'll need to track down what wideband system you have, so the proper one is selected.

Do you have the instructions? You can download them in the downloads section in this forum.